Dissolution and depletion of ferromagnesian minerals from Holocene tephra layers in an acid bog,New Zealand,and implications for tephra correlation

This study examines the depletion of ferromagnesian silicate minerals from a sequence of thin, distal, mainly rhyolitic tephra layers of Holocene age preserved in an acid peat bog (Kopouatai), North Island, New Zealand. The rate of such depletion has been fast, as indicated by the complete loss of biotite from one tephra layer (Kaharoa Tephra), in which it is normally dominant, in only ca. 770 yr. Chemical dissolution is advocated as the likely cause for the depletion, with amphiboles and other mineral grains commonly showing etch pits, microcaves, and other characteristic surface solution features. Theoretical thermodynamic and kinetic models show a marked increase in the rate of dissolution of all ferromagnesian minerals under conditions of low pH (< 4), but that where silica concentrations in solution are high the relative proportions of minerals remaining are unaffected. However, where concentrations of dissolved silica are low, as in most bog environments, the relative proportions of ferromagnesian minerals are affected as well as absolute amounts being decreased. Amphiboles are depleted relative to pyroxenes, consistent with kinetic studies. The results show that the identification and correlation of tephras on the basis of relative abundances of ferromagnesian minerals alone may be unreliable, and emphasise the need to use multiple criteria in such studies.     

鞍山地区中、上鞍山群变质沉积岩中黑云母化学成分及其意义

通过对中、上鞍山群变质沉积岩中黑云母化学成分的对比,确认区内两层位黑云母化学组分存在一定差异,这种差异主要反映了其形成时变质条件的不同。随变质程度增加,区内黑云母的Si、AI~Ⅵ,Fe~(3 )、Mg和K含量增加,而Fe~(2 )、Al~Ⅳ和CH降低,Mg/Fe~(2 )比值从1.00增至2.18。中鞍山群黑云母变质温度为550—620℃,变质压力在5×10~8Pa左右;上鞍山群黑云母变质温度为450-500℃,变质压力低于5×10~8Pa。黑云母含铁系数(f)可作为鞍山地区寻找富铁矿的一种标志。     

The second order characteristic condition for plastic flow

In this paper the second order characteristic (discontinuous bifurcation) condition is derived for the granular flow (fully plastic) equations. This second order bifurcation equation is shown to be formally identical to the first order localization requirement during steady elastoplastic deformation provided the elastic compliance tensor is substituted for the product of the plastic multiplier with the flow Hessian. For isotropic yield and flow functions the invariant form of the characteristic condition is given in detail, as well as an alternative expression in adapted co‐ordinates. The characteristic condition can be regarded as defining a hardening function which is maximized to identify the critical angles. When the method is applied to 3D Coulomb flow, Mohr's 3D fracture plane conditions are obtained uniquely. Copyright © 2003 John Wiley & Sons, Ltd.     

The geochemistry of gem opals as evidence of their origin

Seventy-seven gem opals from ten countries were analyzed by inductively coupled plasma-mass spectrometry (ICP-MS) through a dilution process, in order to establish the nature of the impurities. The results are correlated to the mode of formation and physical properties and are instrumental in establishing the geographical origin of a gem opal. The geochemistry of an opal is shown to be dependant mostly on the host rock, at least for examples from Mexico and Brazil, even if modified by weathering processes. In order of decreasing concentration, the main impurities present are Al, Ca, Fe, K, Na, and Mg (more than 500 ppm). Other noticeable elements in lesser amounts are Ba, followed by Zr, Sr, Rb, U, and Pb. For the first time, geochemistry helps to discriminate some varieties of opals. The Ba content, as well as the chondrite-normalized REE pattern, are the keys to separating sedimentary opals (Ba > 110 ppm, Eu and Ce anomalies) from volcanic opals (Ba < 110 ppm, no Eu or Ce anomaly). The Ca content, and to a lesser extent that of Mg, Al, K and Nb, helps to distinguish gem opals from different volcanic environments. The limited range of concentrations for all elements in precious (play-of-color) compared to common opals, indicates that this variety must have very specific, or more restricted, conditions of formation. We tentatively interpreted the presence of impurities in terms of crystallochemistry, even if opal is a poorly crystallized or amorphous material. The main replacement is the substitution of Si⁴⁺ by Al³⁺ and Fe³⁺. The induced charge imbalance is compensated chiefly by Ca²⁺, Mg²⁺, Mn²⁺, Ba²⁺, K⁺, and Na⁺. In terms of origin of color, greater concentrations of iron induce darker colors (from yellow to “chocolate brown”). This element inhibits luminescence for concentrations above 1000 ppm, whereas already a low content in U (≤ 1 ppm) induces a green luminescence.     

不整合运移通道类型及输导油气特征

在对不整合空间结构特征研究的基础上,提出了油气沿不整合运移的通道类型:宏观上,存在由不整合面之上底砾岩和不整合面之下半风化岩石两种高效运载层组合成的双运移通道型和单运移通道型两种通道类型;微观上,底砾岩连通孔隙、半风化岩石构造卸荷风化裂缝系统及溶蚀孔洞系统可作为油气运移的主要通道。通过对不整合面上、下岩石物性分析,认为半风化岩石“孔洞缝”系统较底砾岩连通孔隙有更高的输导油气的能力。研究结果表明,不同的运移通道类型具有不同的输导油气特征。在地史时期,构造裂缝系统和溶蚀孔洞系统一直是不整合输导油气的主要通道;对于软地层构成的不整合来说,开始应是卸荷、风化裂缝系统和底砾岩连通孔隙共同构成不整合输导油气的主要通道,当上覆沉积载荷达到一定程度后,主要是底砾岩连通孔隙起输导油气通道作用;对于脆硬地层构成的不整合来说,卸荷、风化裂缝系统和底砾岩连通孔隙一直是不整合输导油气的主要通道。     

Distribution of Cd,Pb, Zn and Cu and their chemical speciations in soils from a peri-smelter area in northeast China

An exploratory study on soil contamination of heavy metals was carried out surrounding Huludao zinc smelter in Liaoning province, China. The distribution of total heavy metals and their chemical speciations were investigated. The correlations between heavy metal speciations and soil pH values in corresponding sites were also analyzed. In general, Cd, Zn, Pb, Cu and As presented a significant contamination in the area near the smelter, comparied with Environmental Quality Standards for Soils in China. The geoaccumulation index showed the degree of contamination: Cd > Zn > Pb > Cu > As. There was no obvious pollution of Cr and Ni in the studied area. The speciation analysis showed that the dominant fraction of Cd and Zn was the acid soluble fraction, and the second was the residual fraction. Pb was mostly associated with the residual fraction, which constituted more than 50% of total concentration in all samples. Cu in residual fraction accounted for a high percentage (40–80%) of total concentration, and the proportion of Cu in the oxidizable fraction is higher than that of other metals. The distribution pattern of Pb and Zn was obviously affected by soil pH. It seemed that Pb and Zn content in acid solution fraction increased with increasing soil pH values, while Cd content in acid soluble fraction accounted for more proportion in neutral and alkaline groups than acidic one. The fraction distribution patterns of Cu in three pH groups were very similar and independent of soil pH values. And the residual fraction of Cu took a predominant part (50%) of the total content.     

THERIA_G: a software program to numerically model prograde garnet growth

We present the software program THERIA_G, which allows for numerical simulation of garnet growth in a given volume of rock along any pressure–temperature–time (P–T–t) path. THERIA_G assumes thermodynamic equilibrium between the garnet rim and the rock matrix during growth and accounts for component fractionation associated with garnet formation as well as for intracrystalline diffusion within garnet. In addition, THERIA_G keeps track of changes in the equilibrium phase relations, which occur during garnet growth along the specified P–T–t trajectory. This is accomplished by the combination of two major modules: a Gibbs free energy minimization routine is used to calculate equilibrium phase relations including the volume and composition of successive garnet growth increments as P and T and the effective bulk rock composition change. With the second module intragranular multi-component diffusion is modelled for spherical garnet geometry. THERIA_G allows to simulate the formation of an entire garnet population, the nucleation and growth history of which is specified via the garnet crystal size frequency distribution. Garnet growth simulations with THERIA_G produce compositional profiles for the garnet porphyroblasts of each size class of a population and full information on equilibrium phase assemblages for any point along the specified P–T–t trajectory. The results of garnet growth simulation can be used to infer the P–T–t path of metamorphism from the chemical zoning of garnet porphyroblasts. With a hypothetical example of garnet growth in a pelitic rock we demonstrate that it is essential for the interpretation of the chemical zoning of garnet to account for the combined effects of the thermodynamic conditions of garnet growth, the nucleation history and intracrystalline diffusion. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.

Crystal chemical significance of chemical zoning in dissakisite-(Ce)

Dissakisites from Trimouns dolomite mine, France, have two kinds of single crystals: chemical-zoned and homogeneous types. Back-scattered electron microprobe (BSE) images of these dissakisites reveal both Ca–Al rich dark zones and Fe-ΣREE rich bright zones. Crystal structures of three dark and two bright zones in a chemical-zoned dissakisite and of a homogeneous zone in unzoned dissakisite were refined to individual R indices (about 3.0–5.0%) based on 1,400 observed [|F ₀| > 4σF ₀] reflections measured with MoKα X-radiation using the single crystal diffractometer. The differences in brightness between their BSE images arise from those in coupled substitutions of the elements occupying A2 and M3 sites. The main reason for these differences is that ten-coordinated A2 polyhedra and M3 octahedra are directly linked through their shared edge, which creates a great potential for making this coupled substitution. This zoning indicates that formation of the whole zoned crystal, where each zone could be grown steadily with its crystallographic axes mutually parallel to each other, may be identified as autoepitaxy.     

Methodology for preliminary assessment of Natech risk in urban areas

Concern for natural hazard-triggered technological disasters (Natech disasters) in densely populated and industrialized areas is growing. Residents living in urban areas subject to high natural hazard risk are often unaware of the potential for secondary disasters such as hazardous materials releases from neighboring industrial facilities, chemical storage warehouses or other establishments housing hazardous materials. Lessons from previous disasters, such as the Natech disaster during the Kocaeli earthquake in Turkey in 1999 call for the need to manage low frequency/high consequence events, particularly in today’s densely populated areas. However, there is little guidance available on how local governments and communities can assess Natech risk. To add to the problem, local governments often do not have the human or economic resources or expertise to carry out detailed risk assessments. In this article, we propose a methodology for preliminary assessment of Natech risk in urban areas. The proposed methodology is intended for use by local government officials in consultation with the public. The methodology considers possible interactions between the various systems in the urban environment: the physical infrastructure (e.g., industrial plants, lifeline systems, critical facilities), the community (e.g., population exposed), the natural environment (e.g., delicate ecosystems, river basins), and the risk and emergency management systems (e.g., structural and nonstructural measures). Factors related to vulnerability and hazard are analyzed and qualitative measures are recommended. Data from hazardous materials releases during the Kocaeli, Turkey earthquake of August 17, 1999 are used as a case study to demonstrate the applicability of the methodology. Limitations of the proposed methodology are discussed as well as future research needs.

藏南地区中生代硅质岩的地球化学特征及其成因意义

藏南地区中生代硅质岩包括蛇绿岩套硅质岩(与蛇绿岩共生)和非蛇绿岩套硅质岩两大类.本文重点分析日喀则地区彭错林、夏鲁以及泽当地区的罗布莎、江孜盆地宗卓组及四个剖面的硅质岩.其中,彭错林、夏鲁和罗布莎硅质岩与蛇绿岩共生,江孜盆地宗卓组为非蛇绿岩套硅质岩.分析表明:(1)藏南地区硅质岩剖面地球化学特征鲜明,具有一致性和多样性特点;(2)与蛇绿岩共生的彭错林、夏鲁、罗布莎硅质岩普遍具有高Si、高Fe、低Al特征,大部分微量元素相对于克拉克值亏损,稀土元素总量低,经北美页岩标准化后,Ce异常明显或不明显,重稀土相对轻稀土富集.硅质泥岩的∑REE要明显高于硅质岩;(3)非蛇绿岩套宗卓组硅质岩SiO2含量稍低,Al2O3、TiO2则相反.V、Th、Hf、Ta等不相容元素上亏损程度较小,部分样品含量可接近克拉克值.稀土总量相对较高,页岩标准化配分模式上体现为弱Ce正异常,负Eu异常,轻重稀土分异不明显的平坦型曲线图;(4)地球化学特征指示了,藏南地区硅质岩多数具有明显的热水沉积成因属性,同时有正常陆源组分的加入.其中,夏鲁硅质岩的热水沉积地球化学特征较为典型,而宗卓组硅质岩则表现出受陆源物质加入的影响显著的地球化学特点.